Best Lightweight Water Heaters in 2025

【Unprecedented experience】The high altitude suitability mode allows the machine to run smoothly even when driving the caravan to the high Denver plateau at 9800 feet. Staged combustion technology controls the amount of flame in summer, prevents the water from getting too hot, and saves the limited propane gas available for caravan travel.

【All RV water heaters can be replaced】The Fogatti RV water heater has a wide range of applications. The opening is 13 x 13 inches and the door is 15 x 15 inches. It can replace Suburban and Atwood's 6 gallons tank water heaters, as well as Girard and Furrion's tankless water heaters. If you were previously using a 10 gallons tank water heater, it will need to be retrofitted with an 18 x 18 door.

【Incessant hot water】With 55,000 BTU of power, it can produce a maximum of 2.9 GPM of hot water. Some tank heaters can only store up to 6- 10 gallons of hot water and run out of hot water in 5- 8 minutes, whereas our hot water supply lasts over 20 minutes.

We recommend that all installations of units must be done by the local building and plumbing codes of the installation location and installation be done by a licensed professional.

The tankless design means you don't have to wait 30 minutes for preheating and unlimited use of hot water.

145,000 BTU high heating capacity and maximum 6.3 GPM. It is suitable for 3-4 outlet points, which can satisfy whole family. UEF over 0.81, the high energy conversion rate can effectively reduce energy loss.

【Smaller size and better performance】It is only 1/4 the size of a 50 gallon tank water heater, yet it produces approximately 4.0 GPM of hot water through 90,000 BTU for both bathroom and kitchen hot water demand. The highly integrated components also provide greater safety from water pressure surges without the need to install an expansion tank.

【Fast and endless supply of hot water】The heat exchanger quickly heats the water to a maximum of 140℉ in a short time, and the hot water is quickly piped through to the shower and tap. No need to wait for the water temperature to heat up slowly like a tank water heater. After that it continues to operate at approximately 4.0 GPM for 40 minutes, which is enough time to produce almost 160 gallons of hot water.

【Stable and comfortable temperature】Benefiting from the calculation and control of the heating power 1000/s by the chip, the temperature difference of the water can be precisely controlled within ±2°F.

We recommend that all installations of units must be done by the local building and plumbing codes of the installation location and installation be done by a licensed professional.

The tankless design means you don't have to wait 30 minutes for preheating and unlimited use of hot water.

170,000 BTU high heating capacity and maximum 7.5 GPM. It is suitable for 3-4 outlet points, which can satisfy whole family. UEF over 0.81, the high energy conversion rate can effectively reduce energy loss.

【Smaller size and better performance】It is only 1/4 the size of a 50 gallon tank water heater, yet it produces approximately 5.1 GPM of hot water through 120,000 BTU for both bathroom and kitchen hot water demand. The highly integrated components also provide greater safety from water pressure surges without the need to install an expansion tank.

【Fast and endless supply of hot water】The heat exchanger quickly heats the water to a maximum of 140℉ in a short time, and the hot water is quickly piped through to the shower and tap. No need to wait for the water temperature to heat up slowly like a tank water heater. After that it continues to operate at approximately 5.1 GPM for 40 minutes, which is enough time to produce almost 200 gallons of hot water.

【Stable and comfortable temperature】Benefiting from the calculation and control of the heating power 1000/s by the chip, the temperature difference of the water can be precisely controlled within ±2°F.

【Smaller size and better performance】It is only 1/4 the size of a 50 gallon tank water heater, yet it produces approximately 4.0 GPM of hot water through 90,000 BTU for both bathroom and kitchen hot water demand. The highly integrated components also provide greater safety from water pressure surges without the need to install an expansion tank.

【Fast and endless supply of hot water】The heat exchanger quickly heats the water to a maximum of 140℉ in a short time, and the hot water is quickly piped through to the shower and tap. No need to wait for the water temperature to heat up slowly like a tank water heater. After that it continues to operate at approximately 4.0 GPM for 40 minutes, which is enough time to produce almost 160 gallons of hot water.

【Stable and comfortable temperature】Benefiting from the calculation and control of the heating power 1000/s by the chip, the temperature difference of the water can be precisely controlled within ±2°F.

We recommend that all installations of units must be done by the local building and plumbing codes of the installation location and installation be done by a licensed professional.

The tankless design means you don't have to wait 30 minutes for preheating and unlimited use of hot water.

170,000 BTU high heating capacity and maximum 7.5 GPM. It is suitable for 3-4 outlet points, which can satisfy whole family. UEF over 0.81, the high energy conversion rate can effectively reduce energy loss.

【Outdoor installation to save space】The product is installed outdoors and does not occupy the living space. The bottom built-in forced DC fan eliminates the influence of external wind. So as to ensure the stability of combustion, achieve safety, energy saving and no pollution. We recommend that all installations are carried out in accordance with local building and plumbing codes by licensed professionals.

【Endless water supply without preheating】The heat exchanger quickly heats the water to a maximum of 140°F, which is ready for use without waiting for hot water. It can run at approximately 7.5 GPM for 40 minutes, enough to produce almost 300 gallons of hot water. Make a multi-point water supply for the whole house to meet your family's water needs.

【Precise temperature control and stable temperature】Equipped with a wire controller cord length of 164ft, allowing you to control the water temperature indoors. The burner can be burnt in sections to meet the water temperature demand in the four seasons. Benefiting from the calculation and control of the heating power 1000/s by the chip, the temperature difference of the water can be precisely controlled within ±2°F.

We recommend that all installations of units must be done by the local building and plumbing codes of the installation location and installation be done by a licensed professional.

The tankless design means you don't have to wait 30 minutes for preheating and unlimited use of hot water.

180,000 BTU high heating capacity and maximum 8.1 GPM. It is suitable for 3-5 outlet points, which can satisfy whole family. UEF over 0.81, the high energy conversion rate can effectively reduce energy loss.

We recommend that all installations of units must be done by the local building and plumbing codes of the installation location and installation be done by a licensed professional.

The tankless design means you don't have to wait 30 minutes for preheating and unlimited use of hot water.

180,000 BTU high heating capacity and maximum 8.1 GPM. It is suitable for 3-5 outlet points, which can satisfy whole family. UEF over 0.81, the high energy conversion rate can effectively reduce energy loss.

【Outdoor installation to save space】The product is installed outdoors and does not occupy the living space. The bottom built-in forced DC fan eliminates the influence of external wind. So as to ensure the stability of combustion, achieve safety, energy saving and no pollution. We recommend that all installations are carried out in accordance with local building and plumbing codes by licensed professionals.

【Endless water supply without preheating】The heat exchanger quickly heats the water to a maximum of 140°F, which is ready for use without waiting for hot water. It can run at approximately 6.3 GPM for 40 minutes, enough to produce almost 240 gallons of hot water. Make a multi-point water supply for the whole house to meet your family's water needs.

【Precise temperature control and stable temperature】Equipped with a wire controller cord length of 164ft, allowing you to control the water temperature indoors. The burner can be burnt in sections to meet the water temperature demand in the four seasons. Benefiting from the calculation and control of the heating power 1000/s by the chip, the temperature difference of the water can be precisely controlled within ±2°F.

【Outdoor installation to save space】The product is installed outdoors and does not occupy the living space. The bottom built-in forced DC fan eliminates the influence of external wind. So as to ensure the stability of combustion, achieve safety, energy saving and no pollution. We recommend that all installations are carried out in accordance with local building and plumbing codes by licensed professionals.

【Endless water supply without preheating】The heat exchanger quickly heats the water to a maximum of 140°F, which is ready for use without waiting for hot water. It can run at approximately 5.1 GPM for 40 minutes, enough to produce almost 200 gallons of hot water. Make a multi-point water supply for the whole house to meet your family's water needs.

【Precise temperature control and stable temperature】Equipped with a wire controller cord length of 164ft, allowing you to control the water temperature indoors. The burner can be burnt in sections to meet the water temperature demand in the four seasons. Benefiting from the calculation and control of the heating power 1000/s by the chip, the temperature difference of the water can be precisely controlled within ±2°F.

【Smaller size and better performance】It is only 1/4 the size of a 50 gallon tank water heater, yet it produces approximately 5.1 GPM of hot water through 120,000 BTU for both bathroom and kitchen hot water demand. The highly integrated components also provide greater safety from water pressure surges without the need to install an expansion tank.

【Fast and endless supply of hot water】The heat exchanger quickly heats the water to a maximum of 140℉ in 2 seconds and the hot water is quickly piped through to the shower and tap. No need to wait for the water temperature to heat up slowly like a tank water heater. After that it continues to operate at approximately 5.1 GPM for 40 minutes, which is enough time to produce almost 200 gallons of hot water.

【Stable and comfortable temperature】Benefiting from the calculation and control of the heating power 1000/s by the chip, the temperature difference of the water can be precisely controlled within ±2°F.

Gas Water Heater

InstaShower 6

InstaShower 8 Plus

【Outdoor installation to save space】The product is installed outdoors and does not occupy the living space. The bottom built-in forced DC fan eliminates the influence of external wind. So as to ensure the stability of combustion, achieve safety, energy saving and no pollution. We recommend that all installations are carried out in accordance with local building and plumbing codes by licensed professionals.

【Endless water supply without preheating】The heat exchanger quickly heats the water to a maximum of 140°F, which is ready for use without waiting for hot water. It can run at approximately 5.1 GPM for 40 minutes, enough to produce almost 200 gallons of hot water. Make a multi-point water supply for the whole house to meet your family's water needs.

【Precise temperature control and stable temperature】Equipped with a wire controller cord length of 164ft, allowing you to control the water temperature indoors. The burner can be burnt in sections to meet the water temperature demand in the four seasons. Benefiting from the calculation and control of the heating power 1000/s by the chip, the temperature difference of the water can be precisely controlled within ±2°F.

We recommend that all installations of units must be done by the local building and plumbing codes of the installation location and installation be done by a licensed professional.

The tankless design means you don't have to wait 30 minutes for preheating and without limit the use of hot water.

170,000 BTU high heating capacity and maximum 7.5 GPM. It is suitable for 3-4 outlet points, which can satisfy whole family. UEF over 0.81, the high energy conversion rate can effectively reduce energy loss.

【Endless water supply without preheating】The heat exchanger quickly heats the water to a maximum of 140°F, which is ready for use without waiting for hot water. It can run at approximately 7.5 GPM for 40 minutes, enough to produce almost 300 gallons of hot water. Make a multi-point water supply for the whole house to meet your family's water needs.

【Precise temperature control and stable temperature】Equipped with a wire controller cord length of 164ft, allowing you to control the water temperature indoors. The burner can be burnt in sections to meet the water temperature demand in the four seasons. Benefiting from the calculation and control of the heating power 1000/s by the chip, the temperature difference of the water can be precisely controlled within ±2°F.

【Compact design for easy installation】The tankless design is 1/4 the size of a 50 gallon tank water heater, making it easy to install. The highly integrated components also provide greater safety from water pressure surges without the need to install an expansion tank.