Best Ade Advanced Optics in 2026

Triplet glass lens for excellent Clarity

Leather case with snap closure to hold loupe securely

Three lens bonded together for high defination image

Fit rail-equipped pistols, rifles and shotguns. The laser sight fits onto virtually any firearm with a modern (M1913 Pica tinny or Weaver-style) accessory rail

Exquisite, compact and lightweight design, convenient to carry around. Only weight 2.72oz. Length: 2.4 inch

400 Lumen Cree bright white flashlight operates with a single CR2 battery(INCLUDED)

Newly release for fall 2019 by Ade Advanced Optics. Convenient charging by connecting the laser directly with the included magnetic USB cable. There is no need to remove a battery or plug into a port that will wear out over time

This is a new updated version of the HG54G laser which takes non-rechargeable battery. This new HG54G RECHARGE comes with a built-in lithium polymer battery gives up to 90 minutes per charge, and the built-in battery has approximately 600 life spans. Potentially saves $600+ spending on batteries

Offers the brightest laser allowed by Law. Non-handheld class 3R laser product, < 5Mw power output. Ultra lightweight and compact 1.79"L x 1.06"W x .85"H

Machined from lightweight, extremely durable 7075 aluminum, Mil-Spec hard anodized

Same height above bore as standard-issue sights

Low-profile sights extend only .2" above top rail, don't interfere with primary optics or military IR illuminator /laser sight

LIFETIME WARRANTY! Stock is not included. This for the rubber pad only

For airsoft! Reduces the recoil

Deluxe Military Style Butt Pad with Ergonomic Design

We have made several improvements since it's initial release in 2016. We have made it more durable to withstand recoil and improved the ability to hold zero. Designed in Oregon.

Lenses are precision ground and polished to exacting geometries to virtually eliminate parallax and to provide a very clear, crisp sight picture.

This GREEN dot comes with a picatinny mounting base. It is also compatible with varies handgun mounting plates that replace rear sight dovetail. It is also compatible to Optics Ready pistols such as Glock MOS, Springfield OSP,

STANAG dimension includes mounting base, two through-holes, and proper clearance below the base for STANAG styled scopes

High-profile COMPACT mount for rifles with Picatinny/Weaver rail.

See-through design allows for the use of the original iron sights

Offers the brightest green laser allowed by Law. Non-handheld class 3R laser product, < 5Mw power output. Ultra lightweight and compact. 1.45"L x 1.12"W x 1.04"H

Fit rail-equipped pistols, rifles and shotguns. The laser sight fits onto virtually any firearm with a modern (M1913 Pica tinny or Weaver-style) accessory rail

Smooth metal alloy switches, insures long life and durability. Unique switch design prevents short circuits and malfunctions

Offers the brightest Red laser allowed by Law. Non-handheld class 3R laser product, < 5Mw power output. Ultra lightweight and compact 1.79"L x 1.06"W x .85"H

Fit rail-equipped pistols, rifles and shotguns. The laser sight fits onto virtually any firearm with a modern (M1913 Pica tinny or Weaver-style) accessory rail

Proprietary mounting design provides two spring loaded pillar to push to rail slot for rock solid zero movement. Weight: 1.13oz (Battery included). Does NOT fits Berreta due to extra wide trigger guard.

Heavy duty one piece main tube provides the foundation for precise lens alignment and other components

Extended-range tactical riflescope with 6-25x magnification and 56mm objective lens

Mil-DotBar reticle; precision controls with 140 MOA adjustment

For measurement of ethylene and propylene glycol and brake fluid

Scale range: 32 degree f to -60 degree f

Used on transportation vehicles such as cars tractors tanks ships

Provide a protective roof for outdoor security cameras, such as Nest outdoor camera, Arlo Pro and smaller bullet cameras.

Block direct sunlight to prevent the camera surface gets extreme temperature which likely to reduce camera's life. Also act as rain shade.

Color: WHITE. Made with Ade Advanced Optics military grade polymer.

Push button swivel hook easy to install with Adapter

Aircraft grade aluminum with hard Anodizing matte back finish

Compact, lightweight, Super low profile

Offers the brightest Red laser allowed by Law. Non-handheld class 3R laser product, < 5Mw power output. Ultra lightweight and compact 1.79"L x 1.06"W x .85"H

Fit rail-equipped pistols, rifles and shotguns. The laser sight fits onto virtually any firearm with a modern (M1913 Pica tinny or Weaver-style) accessory rail

Proprietary mounting design provides two spring loaded pillar to push to rail slot for rock solid zero movement. Weight: 1.13oz (Battery included).Does NOT fits Berreta due to extra wide trigger guard.

Provide a protective roof for outdoor security cameras, such as Nest outdoor camera, Arlo Pro and smaller bullet cameras.

Block direct sunlight to prevent the camera surface gets extreme temperature which likely to reduce camera's life. Also act as rain shade.

Color: BLACK. Made with Ade Advanced Optics military grade polymer.

Non-handheld class 3R laser product, <5Mw power output. Ultra lightweight and compact

Fits Springfield XD mod 2 compact, Walter PK380, walther ccp, Ruger SR22, 9 e, SR 9 and ect. Does not fits Springfield xd-s, Glock subs have no rail

Made of aircraft aluminum. Operates with a single cr123a battery(included) that lasts about 2 hours. Ultra light weight: 3.46oz

This optic mounting plate made by ADE Advanced Optics is designed to connect optic sight to certain Smith & Wesson handguns

This mounting plate fits SW Smith & Wesson M&P Full Size, M&P 2.0 Full Size, M&P 22 Full Size, M&P Compact, M&P 2.0 Compact, SD9VE,SD40VE, M&P Shield

This mounting plate does NOT fit Smith & Wesson M&P C.O.R.E Series (Already optics ready), M&P Shield EZ .380, M&P .22 Compact, SW9VE, SW40VE, Sigma

Promotes rapid target acquisition while providing a precise point of aim; getting shots down range and on target fast. Top load System, no need to Remove the sight to change the Battery

The red dot is compatible with Ade handgun mounts for Glock Barreta HK UPS SW MP SIG P226 Springfield Ruger LC9 LC9s LC380 SR9 SR22 SR40 SR45

Red dot has multi brightness level with one adjustment button. Every time you turn on the dot it stays the same brightness level last time it was turned off

This optic mounting plate made by ADE Advanced Optics is designed to connect optic sight to certain Smith & Wesson handguns

This mounting plate fits SW Smith & Wesson M&P Full Size, M&P 2.0 Full Size, M&P 22 Full Size, M&P Compact, M&P 2.0 Compact, SD9VE,SD40VE, M&P Shield

This mounting plate does NOT fit Smith & Wesson M&P C.O.R.E Series (Already optics ready), M&P Shield EZ .380, M&P .22 Compact, SW9VE, SW40VE, Sigma

Designed for Colt 1911 such as -22 to fit Ade rd3-001, rd3-02, rd3-009 and similar style mini Red dot sight such as sight mark mini shot reflex sight. It fits Colt 1911

Covered under Warranty for life

Made using the highest quality materials

The red dot is compatible with Ade handgun mounts for Glock Barreta HK UPS SW MP SIG P226 Springfield. Can also be used with a long range rifle scope for that perfect Backup System

The on/off switch is located at the front of the sight, it is so much easier to press than the Red dots has the switches on the side. 3 MOA. 5 Illumination settings

Lenses are precision ground and Polished to exacting geometries to virtually eliminate Parallax and to provide a very clear, crisp sight picture

We have made several improvements since it's initial release in 2016. We have made it more durable to withstand recoil and improved the ability to hold zero. Designed in Oregon.This GREEN dot comes with a picatinny mounting base.

Lenses are precision ground and polished to exacting geometries to virtually eliminate parallax and to provide a very clear, crisp sight picture.This GREEN dot comes with a picatinny mounting base. Other handgun mounting plates are not included.

It is fits directly to "Optics Ready" pistols that does not need to remove rear sight such as Glock MOS, Springfield OSP. It also fits Canik using Canik provided #1 mount, however the front switch of the sight needs to trim down 2mm.

Padded to distribute the weight of your gun and keep it comfortably on your shoulder

Superb quality - premium heavy duty chafe resistant nylon webbing and durable high impact polymer composite parts. High-quality engineering guarantees years of reliable performance

Swivels offer ease of motion.Expandable up to 36 inch

Heavy duty one piece main tube provides the foundation for precise lens alignment and other components

Extended-range tactical Riflescope with 6-25x magnification and 56mm objective lens

Illuminated Mil-Dot Bar reticle; precision controls with 140 MOA adjustment

Wrong Inventory fixed, customer will receive correct footprint for RMS, not RMR

This optic picatinny mount made by ADE is to connect to certain type of optic sight to standard 1913 picatinny/weaver rail. It does not connect to handgun because most handguns does NOT has a picatinny rail on top

Designed to use on ADE RD3-018 SPIKE, RD3-021 Nuwa, RD3-030 Apollo, Shield RMS/RMSc/RMSw/SMS and Romeo Zero Red dot sights.

Designed to quickly attach/ detach from standard size handgun/rifle with weaver/picatinny rails

Light weight Aircraft Grade Aluminum and Solid Steel Construction.

Operates with a single CR123 battery

ADE Rd3-002 red dot is the entry level red dot that comes with a built-in/non removeable picatinny base. It can only be mounted on the pistols that has a picatinny rail on top. It does NOT works with pistols that does NOT has a picatinny rail on top.

The Build-in picatinny mount CAN NOT be removed and replace with a handgun mounting plate. For red dot sight made to attach pistol mounting plate such as Optics Ready pistols, or mounting plates to replace rear sight, please see ADE’s other models such as RD3-006,RD3-009,RD3-012,RD3-013,RD3-015

Unlimited Eye Relief, 2 MOA Red Dot, Polished/Coated lenses, Parallax Free. ANODIZED ALUMINUM BODY. LED (LIGHT EMITTING DIODE)

Designed to quickly attach/ detach from standard size handgun/rifle with weaver/picatinny rails

Three different target acquisition methods: 200 Lumen flashlight, laser, and flashlight and laser together. Easy Toggle switches

Light weight Aircraft Grade Aluminum and Solid Steel Construction.

The red dot is compatible with Ade handgun mounts for Glock Barreta HK UPS SW MP SIG P226 Springfield. Can also be used with a long range rifle scope for that perfect Backup System

The on/off switch is located at the front of the sight, it is so much easier to press than the Red dots has the switches on the side. 3 MOA. 5 Illumination settings

Lenses are precision ground and Polished to exacting geometries to virtually eliminate Parallax and to provide a very clear, crisp sight picture

This is RD3-012G is GREEN DOT model, there is also a RD3-012 Red dot. The sight has multi brightness level with TWO adjustment button. One to turn bright up and one to turn down. Hold the down button for 3 secs to power off. Every time you turn on the dot it stays the same brightness level last time it was turned off

Comes with a picatinny mounting base. It is also compatible with varies handgun mounting plates(SOLD SEPARATELY) that replace rear sight dovetail. It is also compatible to Optics Ready pistols such as Glock MOS, Springfield OSP, Taurus TORO using Pistol manufacturer provided optic mounting plate(SOLD SEPARATELY).

This GREEN dot fits directly on Glock MOS system with the #1 mount that comes with MOS without needing to remove the rear sight. This glock MOS #01 plate need to obtain from glock, not included in this green dot purchase.