Best Juried Engineering in 2026

Propagation delay time = 60 ns (typ.) at CL = 50 pF, VDD = 10 V

Buffered inputs and outputs

Standardized symmetrical output characteristics

The MCP602 operational amplifiers (op amps) utilize an advanced CMOS technology, which provides low bias current, high speed operation, high open-loop gain and rail-to-rail output swing.

Specifications rated from 2.7V to 5.5V supplies, Rail-to-rail swing at output

Common-mode input swing below ground

The Diotec Semiconductor (Germany) 2N2222A is a NPN bipolar junction transistor housed in a TO-92 package and rated for use in a variety of applications including the roughest of automotive applications

Commercial Grade, Typical hFE of 200, Collector current of 600 mA

Maximum VCEO of 40 V, Manufactured in Germany

Wide Assortment of Operational Amplifiers

Single and Dual Channel Selection

Variety of Unique Sounding Op Amps

The SN74HC27N ’HC27 devices contain three independent 3-input NOR gates

Wide Operating Voltage Range of 2 V to 6 V

Outputs Can Drive Up To 10 LSTTL Loads

The SN74HC27N ’HC27 devices contain three independent 3-input NOR gates

Wide Operating Voltage Range of 2 V to 6 V

Outputs Can Drive Up To 10 LSTTL Loads

Propagation delay time = 60 ns (typ.) at CL = 50 pF, VDD = 10 V

Buffered inputs and outputs

Standardized symmetrical output characteristics

The CD4046B CMOS Micropower Phase-Locked Loop (PLL) consists of a low-power, linear voltage-controlled oscillator (VCO) and two different phase comparators having a common signal-input amplifier and a common comparator input.

Very low power consumption: 70 µW (typ.) at VCO, VCO inhibit control for ON-OFF keying and ultra-low standby power consumption fo = 10 kHz, VDD = 5 V, Source-follower output of VCO control input (Demod. output), 100% tested for quiescent current at 20 V

Operating frequency range up to 1.4 MHz (typ.) at VDD = 10 V, RI = 5 k, High VCO linearity: <1% (typ.) at VDD = 10 V, 5-V, 10-V, and 15-V parametric ratings

Single-Supply or Dual Supplies

Wide Range of Supply Voltage

Low Supply-Current Drain Independent of Supply Voltage: 0.4 mA (Typical) Per Comparator

Single-Supply or Dual Supplies

Wide Range of Supply Voltage

Low Supply-Current Drain Independent of Supply Voltage: 0.4 mA (Typical) Per Comparator

Superior in both electrical and mechanical performance then the generics found on the marketplace today.

Repetitive Reverse Voltage Vrrm Max: 150 V

Forward Current If(AV): 500mA, No. of Pins: 2Pins

These Small Signal Schottky Diode diodes feature very low turn-on voltage and fast guard ring against excessive voltage, such as electrostatic discharges.

Superior electrically and mechanically to the generics found on the marketplace today and rated for long-life, DO-35 (DO-204AH)

SMALL SIGNAL SCHOTTKY DIODES

The BC337-25 is an NPN Transistor commonly used in low power amplifier circuits. The Transistor can provide a maximum gain (hfe) of 400

NPN, Switching and Amplification, Three current gain groups

Compliant to RoHS, Gain (hfe) from 160 - 400.

The BS170 N-Channel enhancement mode field effect transistors are produced using Fairchild's proprietary, high cell density, DMOS technology

High density cell design for low RDS(ON)

Voltage controlled small signal switch

Set-Reset capability, Standardized, symmetrical output characteristics

Static flip-flop operation — retains state indefinitely with clock level either "high" or "low"

Medium speed operation — 16 MHz (typ.) clock toggle rate at 10 V, Noise margin (full package-temperature range) = 1 V at VDD = 5 V, 2 V at VDD = 10 V, 2.5 V at VDD = 15 V

The SN74HC27N ’HC27 devices contain three independent 3-input NOR gates

Wide Operating Voltage Range of 2 V to 6 V

Outputs Can Drive Up To 10 LSTTL Loads

Propagation delay time = 60 ns (typ.) at CL = 50 pF, VDD = 10 V

Buffered inputs and outputs

Standardized symmetrical output characteristics

Propagation delay time = 60 ns (typ.) at CL = 50 pF, VDD = 10 V

Buffered inputs and outputs

Standardized symmetrical output characteristics

Single-supply or dual supplies

Wide range of supply voltage Maximum rating: 2 V to 36 V, Low input bias current, Low output saturation voltage

Low supply-current independent of supply voltage: 200 µA per comparator, Low input offset voltage

The LM2903P devices consist of two independent voltage comparators that are designed to operate from a single power supply over a wide range of voltages

Single-supply or dual supplies Wide range of supply voltage Maximum rating: 2 V to 36 V

Low supply-current independent of supply voltage: 200 µA per comparator, Output compatible with TTL, MOS, and CMOS

Four independent voltage comparators that are designed to operate from a single power supply over a wide range of voltages

Wide Supply Ranges Single Supply: 2 V to 36 V, Dual Supplies: ±1 V to ±18 V, Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: ±36 V, Low Input Offset Current: 3 nA (Typical)

Low Supply-Current Drain Independent of Supply Voltage: 0.8 mA (Typical), Low Output Saturation Voltage, Common-Mode Input Voltage Range Includes Ground

LSTTL input logic compatible – VIL(max) = 0.8 V, VIH(min) = 2 V

CMOS input logic compatible – II ≤ 1 μA at VOL, VOH

Buffered inputs, 4.5 V to 5.5 V operation

The NE556 are Dual Precision timing circuits capable of producing accurate time delays or oscillation

Timing From Microseconds to Hours

Astable or Monostable Operation, TTL-Compatible Output Can Sink or Source Up to 200 mA

The NE555 are precision timing circuits capable of producing accurate time delays or oscillation

Timing From Microseconds to Hours

Astable or Monostable Operation, TTL-Compatible Output Can Sink or Source Up to 200 mA

Excellent Power amplifiers designed for use in low voltage applications

Battery Operation, Minimum External Parts, Ground-Referenced Input Self-Centering Output Quiescent Vol

Wide Supply Voltage Range: 4 V–12 V or 5 V–18 V

The LM2904 devices consist of two independent, high-gain frequency-compensated operational amplifiers designed to operate from a single supply over a wide range of voltages

Single Supply Operation: 3.0 V to 32 V, True Differential Input Stage, Short Circuit Protected Outputs

Low Input Bias Currents, Internally Compensated, Common Mode Range Extends to Negative Supply

BCD-to-decimal decoding or binary-to-octal decoding, High decoded output drive capability

"Positive logic" inputs and outputs……decoded outputs go high on selection, Medium-speed operation… tPHL, tPLH = 80 ns (typ.) @ VDD = 10 V

Standardized, symmetrical output characteristics, 100% tested for quiescent current at 20 V, 5-V, 10-V, and 15-V parametric ratings

Static Operation

Diode Protection on All Inputs

Supply Voltage Range = 3.0 Vdc to 18 Vdc

Third generation Power MOSFETs from Vishay provide the designer with the best combination of fast switching, ruggedized device design and low on-resistance

Dynamic dV/dt Rating, Fast Switching

Repetitive Avalanche Rated, 175 °C Operating Temperature

Propagation delay time = 60 ns (typ.) at CL = 50 pF, VDD = 10 V

Buffered inputs and outputs

Standardized symmetrical output characteristics