Best Quickcar Racing Products in 2026

Rotary Switch

Panel Mount

125 amp 12V

Starter Solenoid, Heavy Duty, Ford Style, Black, Each

Country of Origin: UNITED STATES

Fit type: Vehicle Specific

Item Package Height:5.1 Inches

Item Package Length:5.7 Inches

Item Package Width:5.3 Inches

This product is a Battery Charging Posts Pair w/Bent Mat Bark

Easy to install and attractive accessories for your vehicle

Remote Battery Terminal, 12V, 1-1/4 in Diameter Hole, 3/8-16 in Stud, Bent Bracket, Rubber Cap, Black / Red, Kit

Package Dimensions: 4.5 H x 6.0 L x 4.5 W (inches)

Country of Origin : United States

Fit type: Vehicle Specific

Package Dimensions: 5.0 H x 6.0 L x 5.0 W (inches)

Country of Origin : United States

Fit type: Vehicle Specific

Package Dimensions: 5.75" (L) x 4.25" (W) x 4.5" (H)

Package Quantity: 1

Country of Origin: China

Oil Pressure Gauge, Extreme, 0-100 psi, Mechanical, Analog, 2-5/8 in Diameter, White Face, Built-in Warning Light, Each

Package Dimension : 4.4 " L x 6.0 " W x 4.7 " H

Fit type: Vehicle Specific

Made in China

Package dimensions :27.9 cm (H) x 4.0 cm (L) x 20.4 cm (W)

Package Weight :0.423 kg

Brake Bias Gauge, Dual Gauge, 0-1000 psi, Mechanical, Analog, White Face, 4-1/2 in Wide x 2-3/4 in High Horizontal Panel, Aluminum, Kit

Package Dimension : 6.0 " L x 6.0 " W x 5.0 " H

Fit type: Vehicle Specific

Gauge Panel Assembly, Redline, Oil Pressure / Water Temperature / Oil Temperature / Fuel Pressure / Water Pressure, Black Face, Kit

Includes wiring harness and instructions

Built in warning light

Digital screen on black facing

Gauge Panel Assembly, Redline, Oil Pressure / Water Temperature / Oil Temperature / Fuel Pressure, Carbon Fiber Panel, Black Face, Kit

For use with 12, 24 and 32 Volt Marine Electrical Systems

Capacity - 250 AMPS Continuous, 360 AMPS Intermittent

Ignition Protected

Easy to Use Kit for a Professional Installation

High Current (180A Continuous/1000A Intermittent) Battery Disconnect Switch with Black On/Off Plate

Contains #2 3/8" Copper Lugs, Heavy Duty Heat Shrink, and Rubber Terminal Insulators

Rated to 180A Continuous or 1000A Intermittent

Mounts in 3/4" Hole

Provides Single Power Cut off to Entire Electrical System

Polycarbonate body with brass terminals

Dimensions: 5-1/4" diameter x 2-5/8" depth, 5/16" terminal stud size

For use with 6 to 50 volt marine electrical systems

Rotary Switch

Panel Mount

125 amp 12V

Heavy Duty: ABS plastic housing, durable made for safety use, rear cover insulates terminals against any short of circuits. Design for 2 batteries vehicles, can switch battery 1 / battery 2 separately or both on and off.

Purpose: eliminate any power from the battery when vehicle or boat is not in use, disconnects the battery safely.Avoid battery drain off.

Operation: 1-2-Both-Off,4 positions, 200A continuous at 12VDC, 300A intermittent at 12VDC, 1000A momentary at 12VDC.

Battery Holder Type: 9v battery holder with switch, 9v battery holder with on off switch

Battery Holder Voltage Output: 9V, 1 x 9v battery holder= 9 volt battery holder with leads; Battery Holder Switch Function: ON/OFF switch on 9 volt battery case holder

9 Volt Battery Holder Dimensions: (L*W*H)/2.657" x 1.299" x 0.835"/6.75cm x 3.30cm x 2.12cm

Push button switch with highly visible red button is suitable for any momentary function

Positions: Off – Momentary On

Requires ½ inch mounting hole

Simple Operation:Switch 1&2 = battery 1 & 2 on; Switch off = both off.Rating: 275A DC Continuous (1hr), 455A DC Intermittent (5 min), 1250A DC Cranking (10 sec); Stud Size: 5/16" (8 mm) x 3

Durable Material: This battery disconnect switch is made of ABS plastic housing, tinned copper studs and nuts.Come with 4 stainless steel mounting screws and caps to help fix the switch tightly. 4 Removable side plates provided access for battery cables. 6 pcs 4x5/16" copper lugs, a wrench and 6 pcs heat shrink tubing.

Safety Protection:battery shut off switch can disconnects the battery safely, protect batteries from excessive drain when vehicle or boat is not in use

Compatible: used for top post terminal, 15-17 mm cone / tapering battery NEGATIVE post only, DC 12V-24V system, 200A continuous and 600A momentary at DC 12V, on/off 2 position.

Convenience: vertical knife blade type, easy to install & simple to use. Lift the knife, then power will cut.

Heavy Duty: solid brass made, rust and corrosion resistant, durable made for safety use.

Blue Sea Systems Battery Switch m-Series Selector, part number 6007, is a Selector 4 Position switch. Switches isolated battery banks to all loads or combines battery banks to all loads

IP66 waterproof, ISO 8846 and meets ABYC requirements. Ignition protected—safe for installation aboard gasoline powered boats

Make before break contact design allows switching between battery banks without power interruption

【High Quality】A ABIGAIL Top Post Knife Blade Master Switch is made of Heavy Duty solid brass which is rust and corrosion resistant, durable made for safety use.

【Operation】On/Off 2 position, Battery negative pole 15.5mm-17mm, DC 12V-24V system, 250A continuous and 750A momentary at DC 12V.

【Application & Easy to Use】Battery NEGATIVE post only, Widely used for Car, Vehicle, RV, ATV and Boat batteries, also used for electrical equipment. Vertical knife blade type, easy to install & simple to use.

Selector 4 Position. Switches isolated battery banks to all loads or combines battery banks to all loads. Includes AFD (Alternator Field Disconnect)

Ignition protected—safe for installation aboard gasoline powered boats

IP66 waterproof, ISO 8846 and meets ABYC requirements

When you want to protect your vehicle, a great device is called a battery kill switch. With the battery kill switch you gain the upper hand when it comes to control over thieves who want to drive off with your vehicle. With the key you can shut off the power from the battery so the car will not start. You can easily install a battery switch on your vehicle without any special tools and only about an hour of your time

Waterproof cover can better protect key hole，Max. withstanding current: 12V 500A

Rust and corrosion resistant, Solid brass nuts and washers

Dual Circuit Plus. Simultaneously switches two isolated battery banks or combines battery banks to all loads

Ignition protected—safe for installation aboard gasoline powered boats

IP66 waterproof, ISO 8846 and meets ABYC requirements

Brand new and high quality,Safety and durability

It is a kill switch with safety tether

Racing Safety & Durable, easy install

Compatible: with a long bolt, used for side post terminal, battery side post with 3/8" hole only, recommended to mount on NEGATIVE battery post, DC 12V-24V system, 200A continuous and 600A momentary at DC 12V, on/off 2 position.

Convenience: knife blade type, easy to install & simple to use. Lift the knife, then power will cut.

Heavy Duty: solid brass made, rust and corrosion resistant, durable made for safety use.