Best Lsgoodcare Audio Video Connectors Adapters in 2026

Fast Lock plugs with self-crimping teeth for an easy and reliable connection

Base Diameter = 13.2mm - Tip Diameter = 4.6mm, but can be compressed to the standard 4mm for a firm fit in your speaker or receiver

24K gold plating over steel tip for crystal clear signal and superior durability

Fast Lock plugs with self-crimping teeth for an easy and reliable connection

Base Diameter = 13.2mm - Tip Diameter = 4.6mm, but can be compressed to the standard 4mm for a firm fit in your speaker or receiver

24K gold plating over steel tip for crystal clear signal and superior durability

Fast Lock plugs with self-crimping teeth for an easy and reliable connection

Base Diameter = 13.2mm - Tip Diameter = 4.6mm, but can be compressed to the standard 4mm for a firm fit in your speaker or receiver

24K gold plating over steel tip for crystal clear signal and superior durability

24K gold plating on the Connectors for a lifetime of use, with a crystal clear signal

Double screws, when properly fastened, are said to be as effective as soldering, but clearly with much less hassle.

Accepts wire size up to 4mm

For use in any spring-loaded terminals, or any system requiring bare wire inputs

Fits any wire size up to 12 AWG into spring clip terminals, which can't always be done without flex pin plugs

Double screws for highly secure connection to cable

Note Some devices use RF instead of IR for remote control. The Blast IR Wireless Pro only works with IR devices. Please check the signal type of your remote to ensure it is IR before ordering. .Wireless Distance: 200m (650 ft.), distance may vary due to obstacles, IR Receiver Distance: 7m (30 ft.)Incompatibility : Yamaha HTR 6140, Arris DCX 3520E-M, OSD ATM-7 Speaker Selector

BlastIR Pro receivers are directional and require facing the receiver towards where you will be using the remote. To improve reception and widen the angle of control, we recommend using the included IR receiver cable connected to the main receiver unit.

BlastIR Pro Emitters work best when placed within a few inches of the devices you want to control. For best results we recommend attaching the included optional IR emitter cables so that the emitter is directly over the IR receiver of up to two devices. These are designed to stick directly to the devices that you are trying to control rather than sitting in front of them.

IR Receiver plate receives IR signals directed to it from anywhere in the room

Use Cat5 or Cat6 cabling through the wall to create a hidden connection between input and output plates

Kit includes 3 dual emitter cables, controlling up to 6 devices simultaneously

Extend HDMI 330 ft. (100m) over single Cat5e/6

Support IR Extension, HDMI 1.3, HDCP1.1 & 1.2 protocol

Supports HDMI Input/output of 480i/p, 720p, 1080i/p at 24/50/60 Hz

Forward infrared signals to operate electronic components behind closed doors

IR Receiver has size of 2.25in (L) x 0.5in (W) x 0.5in (H); 9ft cable is attached for connection to IR Repeater

Emitters have a dual emitter y-cable; overall length is 9 feet; final 3 feet may be separated. 38kHz & 56kHz transmit frequency.