Best Current Clamps in 2026

CL120 Clamp Meter measure AC current via the clamp, and AC/DC voltage, resistance and continuity via test leads

Meter has backlit LCD for ease of viewing in low light and is CAT III 600V, Class 2 Double Insulated

RT210 detects the most common wiring problems in standard and GFCI receptacles

Multi -Function T-RMS clampmeter that accurately measures linear or non-linear loads: can measure AC and DC current, AC and DC voltage, Low impedance, Continuity/Resistance/Capacitance, Temperature, Frequency, and Duty Cycle; Easy to use and operate.

Non-Contact Voltage (NCV) Detection: check if a conductor being measured carries a voltage higher than 90V AC without touching any wires; NCV sensor is at the tip of the clamp, press NCV to display EF, bring the sensor close to the conductor under test

Features: LCD display, low battery detection, overload protection, auto power off after 15 minutes, flashlight. Meets IEC safety standard 61010-1 with the CAT III 600V overvoltage protection standard

Accurately Measures: AC/DC voltage, only for AC current (not for DC current), resistance, and also provides diode and continuity tests

Jaw Opening: the Clamp measures the AC current in a conductor up to 26mm without interrupting the circuit

Additional Features: data hold, max reading, and an easy-to-read large LCD

60A AC/DC Amp Clamp Probe

Use with most DMM

Zero/Calibration Function

💥【Convenient】-Compared with buying a delicate and expensive clamp meter,getting a clamp accessory for your DMM is much wiser.It provides you more freedom.the display will not constrain to where you gauge current,but anywhere you want,more friendly to aerial workers,guaranteeing your safety!

💥【Wide Range】-A clamp-on meter can extend the measurement range.AN-605A can be used to test AC/DC amp up to 600A.Note:The flow of electricity can only be measured in one direction at a time,or the currents in opposite directions will cancel each other out,causing wrong measurement results.

💥【Big Open Jaw】-Built with 45mm/1.77 inches large open jaw,it is very easy for you to clamp it on measured thick wire.

Accurate measurements down to 1 mA (.001A) - 80A maximum reading DC/AC

Larger clamp size of .75" (19 millimeter) and improved zero drift stability - Electronic Specialties enlarged the clamp opening as much as possible while still maintaining 1 mA resolution

Minimum/Maximum and Peak Minimum/Maximum functions, Data Hold, Relative Zero - Full DMM built-in

Compatible with any Fluke ScopeMeter test tool, power harmonics analyzer, oscilloscope, multimeter

Compitable with other voltage measurement device with BNC input connectors or if using a meter convert the banana plugs to a BNC connector using the adapter

Designed to provide you with safe, high accuracy measurements for a wide range of applications

【Multiple Test Ranges】The OWON CP-05+ current clamp is ideal for use with automotive oscilloscopes for measuring currents between 1 mA and 400 A. Various current test range, 4A, 40A, 200A, 200-400A test range are available.Low noise level, and high detection accuracy.

【High Performance】The current clamp can take accurate current readings .The current clamps are the ideal tools to extend the current ranges of Oscilloscope tools.Support Auto zero at power on, relative zero correction function.It has Band wide up to 200KHz,support low battery indication .Adopt of amorphous alloy core, with high performance, low loss .

【Easy to Use】The current clamp has range selection settings, set by a slider switch on the handle of the probe. In use there is no need to break into the circuit or disturb the isolation as the opening jaws simply clamp around the current carrying conductor. No electrical contact is required. These current clamps have been designed for use with oscilloscopes.