Best Rockford Fosgate Multichannel Amplifiers in 2026

Bass Restoration Processor, Included ACR-1 Remote Level Control & 20' RJ-14 Cable

Enhanced bass output: The device restores low-end frequencies and provides a more dynamic and immersive listening experience.

Built-in bass maximization circuit: The circuit allows you to adjust the frequency response and control the level of the bass output.

Class D MOSFET Monoblock Power Amplifier

Peak Power at 1 Ohm: 1,600 Watts | RMS Power at 1 Ohm: 1,200 Watts

Frequency Response: 20Hz - 250Hz, On-board Bass EQ Switch with +6 or +12dB boost at 45Hz

The Punch P1000X5 is an ultra-efficient 5-channel amplifier (2.38” x 7.76” x 15.03”) capable of running your entire system without excessive drain on your charging system and rocking 1000 watts of RMS power

Perfect for running a front/rear system and a dedicated subwoofer (RMS Power Output: 75 Watts x 4 + 150 Watts x 1 @ 4-Ohm OR 125 Watts x 4 + 300 Watts x 1 @ 2-Ohm OR N/A + 500 Watts @ 1-Ohm)

RCA inputs can accept both Hi and Low level audio signals without the need of a signal converter and tri-stage protection that covers thermal, over-current and short circuits

Includes: Amplifier. Birth sheet with tested power. Owner’s manual. Mounting Screws. Warranty.

Features: Rockville dB45 3200 Watt/800 Watt Dyno-Certified RMS 4 Channel Amplifier Car Stereo Amp, Loud!!.

Dyno Certified RMS Power Ratings: (Certified Dyno Test / Less than 1 % THD) (Use these ratings when comparing with top brands such as Kicker, Rockford Fosgate, etc). - 2 Ohm: 200 Watts x 4 Channel <1% THD+N . - 4 Ohm:135 Watts x 4 Channel <1% THD+N. - 4 Ohm Bridged: 400Watts x 2 Channel<1% THD+N.

1/0 Gauge 2-Channel Amplifier Installation Kit

Designed for car audio systems up to 2000 watts RMS

Premium Powerflex power and ground wire provides optimal power transfer

Stereo/parallel/bridge-mono mode

User selectable input sensitivity - 0. 775V and 1. 4V

Electronically balanced RCA & XLR inputs; binding post and Speak on outputs

750 watt maximum power full-range amplifier

Amplifier Class: AB

No. of channel: 2/1 Channel

Bridgeable

Variable input voltage

QTD (Quick Thermal Dispersion) technology heat sink

PEAK POWER: Max Power 600 Watts. RMS (50 Watts x 4 @ 4-Ohm or 75W x 4 @ 2-Ohm

RMS POWER: (50 Watts x 4 @ 4-Ohm or 75W x 4 @ 2-Ohm. High Quality KENWOOD sound you can depend on

MARINE CERTIFIED: Conformal coated marine grade circuit board is great for any application including Car, Boat, ATV, UTV etc.

1 x Taramps TS400X4 Full Range Amplifier

Quantity: 1 Amplifier Number of Channels: 04 Max Power at 13.8 VDC 2 Ohms: 400W (4 x 100W RMS) Max Power at: 13.8 VDC 4 Ohms: 252W (4 x 63W RMS) Bridged at 13.8 VDC 4 Ohms: 400W (2 x 200W RMS)

Input Sensitivity: 200mV (Vol=Max) Signal to Noise Ratio: greater than 90dB Frequency Response: (Full Range): 18Hz to 30kHz (-3dB) High Pass Crossover (HPF): 90Hz (-12dB / 8th) Low Pass Crossover (LPF): 90Hz (-12dB / 8th)

The DS 800X4 is a multi-channel amplifier and can be used to sub-bass, bass, mid-bass, mid-range, high-mid and treble.

The Positive/Negative power supply cable is 7 AWG. The output cables wire gauge is 15 AWG and the remote cable is 18 AWG. For Protection fuse or circuit breaker please use 60A.

Short-circuit Protection: Shutdown the amplifier when detect a short- circuit or impedance lower than the supported at the output

Quality - This Class D 4 channel amplifier exhibits quality frequency response rates and crossover network which places this amp at a prominent place. Durable design and highly efficient performance makes this subwoofer amp for car speakers stand out amongst the others.

Power – This Class D 1200 Watt RMS Car Amplifier has a power rating distribution as followed 300x4 @2 Ohms, 192x4 @4 Ohms. The 4 channel amplifier for car speakers also provides a 2-way protection circuitry as a part of its design.

Crossovers- The Taramps Multichannel Car Amplifier offers you the ease of connectivity by providing the feature of crossover. The 2 channel car amplifier provides you with options of fixed 90Hz Highpass & Lowpass crossovers.

Illuminated Hifonics Badge

SPC - Simpatico Coil Design, HSMD - Hifonics Surface Mount Design

PWM MOSFET Power Supply for Maximum Current Levels

RMS Watts @ 4 Ohm Stereo 12.6V:   1050 Watts X 1 Channel / RMS Watts @ 2 Ohm Stereo 12.6V: 1600 Watts X 1 Channel / RMS Watts @ 1 Ohm Stereo 12.6V: 2500 Watts X 1 Channel

Nominal power output 1ohm(watts): 5000 Watts, Max music power: 10000 Watts

Frequency Response   20Hz~250KHz

HUGE POWER IN A SMALL PACKAGE - 1,600 Watts gives you all the power you need tucked away and out of sight, keeping your vehicle looking clean and neat.

WIDE RANGE OF APPLICATIONS - Ranging from 2-8 ohms, this amplifier will allow you to use a variety of speakers for your specific application. Never again will you need to worry about having the right amp for the job.

EXTREMELY POWER EFFICIENT AMPLIFIER - Push an amazing amount of power to your system while only drawing minimal power from your vechicle's battery.

1200 W MAX Power, 4 Channel 225 W X 4 RMS @ 2 ohm 113 W X 4 RMS @ 4 ohm 450 W X 2 RMS Bridged @ 4 ohm

Full Range Class A/B, MOSFET Power Supply

High and Low Level Inputs

1000 WATT POWER: The Pyle Dual Channel Car Amplifier is perfect for your vehicle's sound system. Gives you up to 1000W bridgeable output. Features variable subwoofer crossover, variable gain control and high level low impedance MOLEX input connector

SILVER-PLATED RCA PORTS: The RCA ports are silver-plated for eliminating signal loss. The subsonic filter allows low-end interference to be cut so your speakers will always deliver the highest quality audio

DISTORTION-FREE: The MOSFET pulse width modulation power supply allows for a clean distortion-free signal to your compact speakers providing you w/ crisp and clear audio for an outstanding music experience

2 channels x 750 watts @ 2 ohms

2 channels x 325 watts @ 4 ohms

1 channel x 1,500 watts (mono bridged) @ 4 ohms

100 W MAX Power @ 2 Ohm x 2 Channels

50 W MAX Power @ 4 Ohm x 2 Channels

Full-Range, Class A / B Topology

AMAZING POWER - Capable of 1150 Watts Max with high efficiency in mind gives you the best of both worlds. You'll have all the power you need while utilizing state-of-the-art technology that requires less energy.

WIDE RANGE OF APPLICATIONS - Ranging from 1-4 ohms, this amplifier will allow you to use a variety of speakers for your specific application. Never again will you need to worry about having the right amp for the job.

FULL RANGE AMP - If you are looking for an amplifier that can handle the full frequency range then look no further! Wire the most powerful midranges, tweeters, drivers, or coaxial to this full range series.

110 W/Ch. (6 Ohms, 1 kHz, 0.9% THD, 1 Channel Driven, FTC); 65 W/Ch. (8 Ohms, 20 Hz-20 kHz, 0.7% THD, 2 Channels Driven, FTC)

HDMI 2.0a Support for 4K/60 Hz, 3D,Audio Return Channel, DeepColor, x.v.Color, Lip-sync, Dolby True HD, DTS-HD Master Audio, DVD-Audio, Super Audio CD, Multichannel PCM, and CEC

Built-in Bluetooth to stream virtually any audio from your smartphone, tablet, or PC to your home theater for clear and powerful sound

400 W MAX Power @ 2 Ohm x 2 Channels

200 W MAX Power @ 4 Ohm x 2 Channels

800 W MAX Bridged Power @ 4 Ohm x 1 Channels

1000-WATT POWER: The Crunch PowerDriveX Car Stero Amplifier boasts 1000 Watts power; 2 x 250 watts at 4 ohms, 2 x 500 watts at 2 ohms, 1 x 1000 watts at 4 ohms bridged

2 CHANNEL AMP: 2 Channel amplifier with Low noise pre amplifier with Rugged MOSFET pulse width modulation power supply; Series A/B car amplifier; Maximum low voltage signal from the source unit comes into the amplifier circuit with minimal distortion

INPUTS/OUTPUTS: Low level RCA inputs and outputs; Audio inputs: Unbalanced inputs (RCA) Audio outputs: Line output (RCA)

Operating voltage 9 – 16V RMS power @ 4 ohms 90WRMS power @ 2 ohms 110W RMS bridged power @ 4 ohms 220W Total peak power 880W

Frequency response 20Hz – 20kHz @ -1dB THD + N at rated power (20Hz – 20kHz)<1% Line-in signal-to-noise ratio (reference to 1 watt)>75dB

Maximum high input signal level 12V High input maximum sensitivity 0.5V Maximum line input signal level 5V Line input maximum sensitivity 0.2V

6 CHANNEL BRIDGEABLE AMPLIFIER: Pyle’s PLMRA630BT is engineered as a 6 Channel bridgeable marine amplifier that powers up your speaker and is universally compatible. It has a bridge mode selection switch and high or low electronic crossover network

2.1 BLUETOOTH CONNECTIVITY: Built with 2.1 Bluetooth connectivity that has a wireless range of 25+ feet. Compatible with all Bluetooth devices like iPhone, Android, iPad and tablets. It even has a smart auto connect that remembers device pairing info

WATERPROOF & WEATHERPROOF: The audio amplifier is waterproof with its marine grade rating of IP-01. It’s constructed with silver-plated stereo speaker output terminal connectors to combat weather corrosion with long term us

Competition Grade Class D Monoblock Amplifier

Peak Power at 1 Ohm: 9,000 Watts | RMS Power at: 3,000 Watts.

Stable at 1 Ohm, Frequency Response: 15 Hz to 250 Hz

Excellent for voice as well as bass

2 ohms

1200 watts

Compact Size

High- and Low- level inputs

Selectable Output and Variable Adjustment Crossovers

RMS Power @ 1 ohm: 1400W (13.2v) or 1800W (14.4v); RMS Power @ 2 ohm: 700W (13.2v); RMS Power @ 4 ohm: 350W (13.2v)

The car monoblock amplifier is strappable (slave/master switch) which gives you the ability to connect two amplifiers and generate 3600 watts rms power at 2 ohms

Variable adjustment controls feature gains, subsonic, bass boost, low pass filter, and phase settings so you can get the exact sound you are looking for out of your amplifier

HIGH PERFORMANCE CAR AUDIO AMPLIFIER | One of the best values you will find for a car amplifier for cars in the market! This 12v car amplifier features: 120W x 4 RMS @ 2 Ohm / 200W x 4 MAX, Freq: 10Hz - 35KHz, <0.1% TDH, Built-In OEM Line Converter, Bass Boost 0~12dB, and Ground Loop Isolator. 12-volt output, This multi-channel amplifier for cars provides a real punch for your cars speakers or subwoofers!

PRODUCES POWERFUL, CLEAN, FULL SOUND | Don't settle for weak sounding or underperforming car amplifiers. Your car audio system would not be complete without our multi-channel Massive amplifier. This car audio amplifier features: Built-in OEM line converters with RCA inputs that can take a high-level speaker signal at up to 9 Volts directly in. Full MOSFET with High Grade Switching Devices. Input Level 0.2-9.0v

QUALITY TESTED AND GUARANTEED TO ALWAYS REACH ITS RATED POWER | Get more wattage and quality sound for less money! That is our guarantee! You don't need to set the gains to low to avoid distortion. These car amplifiers provides high power with low efficiency. Also, by sensing the DC offset of a factory radio it can activate the ATO (Auto Turn On) feature and Next Generation Advanced 5 Way Protection Circuitry.